How To Test Heat Strips In Air Handler

Download Commodity

A uncomplicated guide to test a conventional or water heating chemical element

Download Commodity

This is a general guide to test whatsoever type of heating element for failure using an multimeter to measure the resistance of the element.

1
Know the resistance of the chemical element should be this can be calculated using known values: ^[1]
- R = (Five x 5) / P [Where V is the voltage powering the chemical element, P is the power the element uses and R is the resistance.] (An example adding is shown in the tips section)
ii

Now nosotros know what resistance we are looking for we tin can check the element.

Advertisement
3
Use a multimeter to observe resistance. Prepare the multi-meter to the resistance setting with an appropriate measuring scale selected. Measure the resistance past disconnecting the heating element from whatsoever ability source, and connecting the multimeter leads to the terminals of the heating element.^[2]
- If the reading is the same or very close to that of the calculated value, then the element is OK and the fault lies elsewhere.
- If the reading is a lot higher than the calculated value, the chemical element is failing and won't be heating fully.
- If the reading is a lot lower than the calculated value the element, it is failing and volition be heating too much or not at all if function of the element has shorted or exploded.

1
- Disconnect the h2o heater from power source.^[three] If it has a disconnectable plug, unplug it. If it does not have a plug, disconnect ability by turning off the ability breaker or removing the fuse.
ii

Bleed the water from the water heater. Locate the h2o valve at the bottom of the water heater. Attach a garden hose to the elimination valve and plow the valve using a wrench. You will notice a relief valve nearly the superlative of the water heater, you can flip the handle upwards to open it. By doing this it volition allow air into the tank causing the h2o to flow out more apace.^[iv]
3

Wait for the tank to fully empty. Locate the heating element.
4

Remove the electric wires leading to the heating element.

Then remove the heating element using a socket or a wrench and y'all can now check the element equally shown in first method.

Add New Question

Question

Why do I multiply two voltages?

Power formula states that P=IV. Ohms police states that 5=IR or I=V/R. Substitute 5/R for I in the ability formula gives us P=V/R*5 or 5*V/R, so resistance of the element should be the voltage squared divided past the ability.
Question

How can I tell if the switch or the element is bad?

If the resistance is higher than calculated or it's space (so the circuit is open), and then you lot tin can assume that the heating element has gone bad. Same affair applies to the switch - if afterwards setting the switch to the "on" position, the resistance is space, then it means that the switch doesn't shut the circuit and it'southward broken.
Question

What would cause a microwave to not heat up nutrient?

Debra Bish

Community Respond

If your microwave oven quits heating food, information technology's time for a new microwave oven. There is usually non much else one tin can do when this happens.

See more than answers

Ask a Question

200 characters left

Include your email accost to get a bulletin when this question is answered.

Submit

Show More Tips

Thanks for submitting a tip for review!

Advertising

Take intendance when dealing with electricity. If you're not confident in your ability to work with electricity then don't practice information technology. Ask some one who is, such as an electrician or an electrical engineer.

Advertizing

Things You'll Need

Thank you to all authors for creating a folio that has been read 358,498 times.

Source: https://www.wikihow.com/Test-a-Heating-Element